Juniper certsexpert download Full Version Jn0-682 Exam by Giovanna q78 vce pdf

Page: 11 / 11

Juniper JN0-682 Exam Overview :

Exam Name:	Data Center Professional (JNCIP-DC)
Exam Code:	JN0-682 Dumps
Vendor:	Juniper	Certification:	JNCIP-DC
Questions:	154 Q&A's	Shared By:	giovanna

Question 44

You are asked to configure JTI on the QFX Series devices in your data center fabric. You must use sensors with the least amount of latency. Which type of sensor should you use in this scenario?

Options:

Python sensors

JTI native sensors

analog sensors

JTI OpenConfig sensors

Discussion

Wyatt

Passed my exam… Thank you so much for your excellent Exam Dumps.

Arjun Sep 18, 2024

That sounds really useful. I'll definitely check it out.

Reeva

Wow what a success I achieved today. Thank you so much Cramkey for amazing Dumps. All students must try it.

Amari Sep 1, 2024

Wow, that's impressive. I'll definitely keep Cramkey in mind for my next exam.

Ava-Rose

Yes! Cramkey Dumps are amazing I passed my exam…Same these questions were in exam asked.

Ismail Sep 18, 2024

Wow, that sounds really helpful. Thanks, I would definitely consider these dumps for my certification exam.

Anaya

I found so many of the same questions on the real exam that I had already seen in the Cramkey Dumps. Thank you so much for making exam so easy for me. I passed it successfully!!!

Nina Oct 14, 2024

It's true! I felt so much more confident going into the exam because I had already seen and understood the questions.

Question 45

You are troubleshooting a problem with traffic not reaching a remote VTEP. Referring to the

exhibit, what is the reason for the problem?

Questions 45

Options:

A conflict exists with the VLAN-to-VNI mapping.

The local VTEP is misconfigured with the wrong VNI.

No VTEP is configured on peer 192.0.2.20.

The remote VTEP does not have the correct VNI configured.

Discussion

Question 46

After configuring an IP fabric using EBGP as you protocol, you notice that not all of the routers are showing up in the routing tables. You have verified that all adjacencies have formed, and place and configured properly.

In this scenario, which statement is true?

Options:

The routers have not been configured with the multipath multiple-as parameter.

The routers have not been configured using the bfd-1 Liveness-detection parameter.

The routers have not been configured using the multihop parameter.

The routers have not been configured using the add-path parameter