New Year Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: get65

Cisco Updated 200-301 Exam Questions and Answers by atticus

Page: 27 / 58

Cisco 200-301 Exam Overview :

Exam Name: Cisco Certified Network Associate
Exam Code: 200-301 Dumps
Vendor: Cisco Certification: CCNA
Questions: 970 Q&A's Shared By: atticus
Question 108

What is a requirement when configuring or removing LAG on a WLC?

Options:

A.

The Incoming and outgoing ports for traffic flow must be specified If LAG Is enabled.

B.

The controller must be rebooted after enabling or reconfiguring LAG.

C.

The management interface must be reassigned if LAG disabled.

D.

Multiple untagged interfaces on the same port must be supported.

Discussion
Ava-Rose
Yes! Cramkey Dumps are amazing I passed my exam…Same these questions were in exam asked.
Ismail Sep 18, 2024
Wow, that sounds really helpful. Thanks, I would definitely consider these dumps for my certification exam.
Miriam
Highly recommended Dumps. 100% authentic and reliable. Passed my exam with wonderful score.
Milan Sep 24, 2024
I see. Thanks for the information. I'll definitely keep Cramkey in mind for my next exam.
Peyton
Hey guys. Guess what? I passed my exam. Thanks a lot Cramkey, your provided information was relevant and reliable.
Coby Sep 6, 2024
Thanks for sharing your experience. I think I'll give Cramkey a try for my next exam.
Neve
Will I be able to achieve success after using these dumps?
Rohan Oct 24, 2024
Absolutely. It's a great way to increase your chances of success.
Question 109

Drag and drop the Rapid PVST+ forwarding slate actions from the loft to the right. Not all actions are used.

Questions 109

Options:

Discussion
Question 110

Refer to the exhibit.

Questions 110

An engineer is configuring an EtherChannel using LACP between Switches 1 and 2 Which configuration must be applied so that only Switch 1 sends LACP initiation packets?

Options:

A.

Switch 1 (config-if)#channel-group 1 mode on

Swrtch2(config-if)#channel-group 1 mode passive

B.

Switch1(config-if)#channel-group 1 mode passive

Switch2(config-if)#channel-group 1 mode active

C.

Switch1{config-if)£channel-group 1 mode active

Switch2(config-if)#channel-group 1 mode passive

D.

Switch1(config-if)#channel-group 1 mode on

Switch2(config-if)#channel-group 1 mode active

Discussion
Question 111

Refer to the exhibit.

Questions 111

How should the configuration be updated to allow PC1 and PC2 access to the Internet?

Options:

A.

Modify the configured number of the second access list.

B.

Add either the ip nat {inside|outside} command under both interfaces.

C.

Remove the overload keyword from the ip nat inside source command.

D.

Change the ip nat inside source command to use interface GigabitEthernet0/0.

Discussion
Page: 27 / 58
Title
Questions
Posted

200-301
PDF

$40.25  $114.99

200-301 Testing Engine

$47.25  $134.99

200-301 PDF + Testing Engine

$61.25  $174.99