Cisco Updated 350-601 Exam Questions and Answers by zayyan

 Option B is the correct configuration that implements the traffic capture that meets the requirements. The configuration sets the flow timeout to 30 seconds, which matches the destination flow analyzer’s limit. The configuration also enables MAC packet classification and layer 2-switched flow monitoring on the interface ethernet 1/1, which belongs to VLAN 10. This allows the switch to capture the traffic from VLAN 10 and send it to the flow analyzer for troubleshooting. References:

• Cisco Nexus 9000 Series NX-OS System Management Configuration Guide, Release 9.3(x) - Configuring NetFlow [Cisco Nexus 9000 Series Switches], Configuring NetFlow, Configuring NetFlow
• Cisco Nexus 9000 Series NX-OS System Management Configuration Guide, Release 9.3(x) - Configuring NetFlow [Cisco Nexus 9000 Series Switches], Configuring NetFlow, Configuring Layer 2-Switched NetFlow

The FCoE Initialization Protocol (FIP) uses a 24-bit FC-MAP and concatenates a 24-bit Fibre Channel ID to create a fabric-provided MAC address. This is part of the FIP’s role in establishing and maintaining the virtual links between an E-Node and the Fibre Channel Forwarder (FCF). The MAC address is essential for the E-Node to participate in FCoE communications within the fabric. The process ensures that each E-Node has a unique address on the Ethernet network, which encapsulates the Fibre Channel frames for transport. References := Cisco MDS 9000 Series FCoE Configuration Guide, Release 9.x

The configuration snippet in the exhibit shows that VSAN 100 is allowed on interface Ethernet1/12 with the command “switchport trunk allowed vsan 100”. This means option B, “Allow VSAN 100 on interface eth1/12”, is the correct answer. In Cisco Data Center Core Technologies, it’s essential to allow specific VSANs on an interface to enable traffic flow for those VSANs.References: Implementing and Operating Cisco Data Center Core Technologies (DCCOR) - Configuring FCoE

 This configuration ensures that if AAA servers cannot be reached, the switch will fall back to using the local user database for authentication when accessing the console. The fallback error local keyword specifies that the local database should be used in case of an error in reaching the AAA servers1.

References := For more information on configuring AAA on Cisco MDS switches, you can refer to Cisco’s official documentation and community discussions which provide insights into setting up authentication methods for different access scenarios1. These resources explain how to configure the switch to handle authentication locally when remote AAA servers are not available.