Oracle crack4sure 1z0-902 Actual Questions by Aysha q24 vce pdf

Page: 5 / 6

Exam Name:	Oracle Exadata Database Machine X9M Implementation Essentials
Exam Code:	1z0-902 Dumps
Vendor:	Oracle	Certification:	Oracle Exadata
Questions:	85 Q&A's	Shared By:	aysha

Question 20

What does the following command do?

root@rul6 -]# for j in {01..23} ; do ipmitool sunoem cli "set /SP/network/test ping=192.168.1.1$j'' ; done

Options:

Sets the address for each storage and database server's /SP during installation to enable ping testing from the management network, run from the first database server.

Verifies that the ILOM management network is working before installation of all storage and database servers in a full rack Exadata X9M-2, run from the first database server.

Verifies that the ILOM management network is working after OEDA configuration has completed for all storage and database servers in a full rack Exadata X9M-2, run from the first database server.

Sets the test address for the RoCE network for all storage and database servers in a full rack Exadata X9M-2, run from the first database server.

Discussion

Question 21

An Exadata X9M-2 Elastic Rack with 4 Database Servers and 8 HC Storage Servers and 3-phase 24kVA PDUs is being installed in a Data Center. However, the Data Center is only providing enough power for a single cable from each PDU. Which statement is correct?

Options:

A splitter cable can be used to provide power to all PDU cables.

The power cables from the servers to the PDUs can be rearranged inside the rack following OECA guidance to utilize a single PDU power cable.

The installation cannot proceed until two power feeds are available per PDU.

The installation can go ahead, no change is required.

Discussion

Question 22

You are working on a remote Exadata Database Machine with current software and firmware. You now need to start a storage server after hardware maintenance.

Which ILOM command starts the storage server?

Options:

-> start /System

-> start /SP/console

-> set /SYS power_state=ON

You must be physically present in the data center to start an Exadata Storage Server.

-> start /SYSTEM/power

-> start /SYS/power

Discussion

Anaya

I found so many of the same questions on the real exam that I had already seen in the Cramkey Dumps. Thank you so much for making exam so easy for me. I passed it successfully!!!

Nina Oct 14, 2024

It's true! I felt so much more confident going into the exam because I had already seen and understood the questions.

Freddy

I passed my exam with flying colors and I'm confident who will try it surely ace the exam.

Aleksander Sep 26, 2024

Thanks for the recommendation! I'll check it out.

Peyton

Hey guys. Guess what? I passed my exam. Thanks a lot Cramkey, your provided information was relevant and reliable.

Coby Sep 6, 2024

Thanks for sharing your experience. I think I'll give Cramkey a try for my next exam.

Lennie

I passed my exam and achieved wonderful score, I highly recommend it.

Emelia Oct 2, 2024

I think I'll give Cramkey a try next time I take a certification exam. Thanks for the recommendation!

Question 23

What are two recommended configuration best practices for backup and recovery on Exadata?

Options:

Placing the backup network on dedicated switches installed in the top of the rack (ToR) has the benefits of isolating the backup network from other workloads and providing a greater level of control.

Even if the backup was limited to writing to four tape drives, eight channels could be specified to expedite the restore process.

The internal Recovery Appliance backup and restore processing is optimized when the RMAN FILESPERSET parameter is set to 1 for the level 1 incremental backup set.

When off-site long-term backup retention is needed, use Oracle Database Backup Cloud Service as a low-cost, offsite scalable storage for a disaster recovery solution.