Microsoft Updated AZ-220 Exam Questions and Answers by safiyah

You have 100 devices that connect to an Azure IoT hub.

You need to be notified about failed local logins to a subnet of the devices.

Which three actions should you perform in sequence? To answer, move the appropriate actions from the list of actions to the answer area and arrange them in the correct order.

You have 1,000 devices that connect to an Azure IoT hub.

You are performing a scheduled check of deployed IoT devices. You plan to run the following command from the Azure CLI prompt.

az iot hub query --hub-name hub1 --query-command "SELECT * FROM devices WHERE connectionState = 'Disconnected'"

What does the command return?

Note: This question is part of a series of questions that present the same scenario. Each question in the series contains a unique solution that might meet the stated goals. Some question sets might have more than one correct solution, while others might not have a correct solution.

After you answer a question in this section, you will NOT be able to return to it. As a result, these questions will not appear in the review screen.

You are developing a custom Azure IoT Edge module.

The module needs to identify the device ID of the local device.

Solution: You configure the module to read the ProductInfo property of ModuleClient.

Does this meet the goal?

You have sites that contain loT devices as shown in the following table.

You have an Azure subscription.

You need to create the Azure loT Edge devices shown in the following table.

Which type of gateway pattern should you use for each loT Edge device? To answer, drag the appropriate gateway pattern types to the correct devices. Each pattern type may be used once, more than once, or not at all. You may need to drag the split bar between panes or scroll to view content.

NOTE: Each correct selection is worth one point.