CompTIA Updated XK0-005 Exam Questions and Answers by winston

The %iowait value represents the percentage of time the CPU is waiting for I/O operations to complete. A high %iowait value suggests the system is bottlenecked by disk I/O, which could lead to slow response times. Addressing disk I/O bottlenecks would improve performance.

This is because the port 22/tcp is shown as filtered by nmap, which means that nmap cannot determine whether the port is open or closed because a firewall or other device is blocking its probes. If the SSH server was not running on the remote server, the port would be shown as closed, which means that nmap received a TCP RST packet in response to its probe. If the remote SSH server was using SSH protocol version 1, the port would be shown as open, which means that nmap received a TCP SYN/ACK packet in response to its probe. If the SSH host key on the remote server had expired, the port would also be shown as open, but the SSH client would display a warning message about the host key verification failure. Therefore, the best explanation for the filtered state of the port 22/tcp is that a firewall is preventing nmap from reaching the SSH server.

You can find more information about nmap port states and how to interpret them in the following web search results:

Nmap scan what does STATE=filtered mean?

How to find ports marked as filtered by nmap

Technical Tip: NMAP scan shows ports as filtered

The systemct1 reboot command will restore the server to its usual target by rebooting it. This will cause the server to load the default target specified in /etc/systemd/system.conf or /etc/systemd/system/default.target files. The telinit 0 command would shut down the server, not restore it to its usual target. The systemct1 get-default command would display the default target, not change it. The systemct1 emergency command would switch the server to emergency.target mode, which is even more restrictive than rescue.target mode. References: [CompTIA Linux+ (XK0-005) Certification Study Guide], Chapter 17: System Maintenance and Operation, page 516.